My bike accuse error 19, and the Diag Mode 20 appears OFF
What can I do to fix it, the switch is Ok, but i don`t know where is the fail, may be the sensor its burn or something... need help
The XT has 30.000 kms. and it is 2006... brand new!!!

Best regards!

I have already replied to this question from the PM you sent me.

************************************************** ************************************************** ******************

Private Message: Re: 700cc conversion Recipients: chequeneglia

http://www.xt660.com/smooth/statusicon/post_old.gif 06-04-08, 09:25
http://www.xt660.com/images/avatars/avatar68_9.gif Kev http://www.xt660.com/smooth/statusicon/user_online.gif
Resident Tech Guru / XT Supporter
http://www.xt660.com/images/ranks_helmets/admin.png
http://www.xt660.com/images/ranks_helmets/supporter.png
Join Date: May 2006
Location: Brisbane
Posts: 1,547
http://www.xt660.com/smooth/reputati...tation_pos.gif


Re: 700cc conversion
Error 19 is the black/blue wire that goes to the crankshaft speed sensor, it is not getting a signal when the starter is pushed. Trace & check this wire from the ECU to the speed sensor plug.

Not sure why you are checking the side stand switch in Diag 20.

Cheers
Kev

Quote:
Originally Posted by chequeneglia
Hi Kev, sorry the late of my reply, the cylinder was instaled in another XT that has a little scratch

Now my bike display the Error 19.... and in Diag Mode 20 appears OFF... the switch is OK... what do yo think its the problem, may be the computer? may I reset de computer?

Best regard and thanks... how it`s your new XT 700?

Had er 1 and 2 come up this morning along with temp light on all time but bike runs fine apart from no speedo any idea's guys ?

ER 1 & ER2 are no signals to the ECU. Check your connections at the dash & main ECU.

Cheers Kev will do later when i get home from work.

changed codes for 2007?
 

Hi,
i have checked diag mode on my bike and i cant find diag mode 02 (atmospheric pressure). From -d01- on the display it continues to -d03-. Is there any changes for 2007? Also i found some codes (d30, d36, d48, d50...)which are not listed in the explanation posted on this forum?!
Thanks for help.

Air pressure sensor is still read from d03 in the diag screen, d30 is for coil out put test, d36 is for injector out put test, d48 AIS put put test, d50 is fuel injection relay out put test.

A out put test is when the ECU sends a voltage to a component to activate it when carrying out tests.

Thanks Kev, you are The best. :blob5:

Good afternoon! Making of 45 teeth crown wheel late and put the crown of 43 teeth. There is way to adjust the speed in the panel?

There is no way of adjusting the speedo drive speed through the dash. I would recommend you fit a speedo healer you can find out more about this in the Modification Index.

http://www.xt660.com/showthread.php?t=630