Hello,
I asked to Valli (local yamaha dealer) the actual price of Micro GPT. The answer was 58 Euros + IVA (20%). So the total price is 69.6 Euros. Vatraxos, I think is not convenient, because of shipping.

I seen the Koso link attached by KEV. It's very nice, and I agreed with Platty. It may be an interesting solution.

In any case, if you need other don't hesitate to ask me.

Bye. :thumbsup::thumbsup::thumbsup:

Thanks a lot.
I have also contact GPT official store and they have also replied for 70euros including shipping.
At least we have cross-checked the price :P

This is what I fitted:-

http://s106.photobucket.com/albums/m...t=IMG_4772.jpg

I got it from:-

http://www.heidentuning.com/p/28/152...-mini-electric

I like your set up xtrlee, particually the electronic analog tacho.:blob7: I want one of them please, but I'll have to wait. Thanks for the link. :ytiller:

Xtrlee, that's perfect!!!..
I also prefer analog tachometer's. Is it operating properly??
Could you please give me a short description. Thanks a lot for the support!

GPT's are about 80 euro now...

I have one of these but use it to set up clutches on Mini Moto's. I used it to set up the tickover then will fit at some point to the XT. Not sure where it came from though as a friend gave it to me. If you search mini moto parts shops as the mini moto guys use them all the time to set the Spinning clutches when racing to get them to kick in at just the right time.

A...

Tachometer
 

I installed an anolog rev counter, connted it to ECU as i have an 06 XTR, but it seem to be under reading by 1500-2000 rpn, any ideas?

Hi, I have finally managed to find a cheap GTP micro rpm.
I have installed in yesterday and it seems that it's working dine for low rpm (1200-3000) but after that it goes too high with maximum rpm up to 115000.
Any ideas? Gianni1951 do you have the same problem??

Hi,

no, I haven't this problem. If the setting is correct (I mean kind of engine and number of cylinder), may be you have some extra impulses if your electrical cable is too much near to solenoid. You can try to move the cable in between the coil and spark plug. Nearer spark plug. I'm sorry, but there is no explanation to your question. Is a non sense. I think you have electrical noise received by rev cable. You can try also to shorter the cable to reduce the sensitivity.

Ciao.