![]() |
![]() |
![]() |
|
|
XT660Z T�n�r� Tech Section Tyres, Mods, Luggage & Long distance preparation |
![]() |
|
Thread Tools | Display Modes |
#
1
|
|||
|
|||
?
Last edited by toshbiker; 09-08-12 at 22:11. |
#
2
|
|||
|
|||
This is a first, or at least the first time anyone has told of this problem.
The adjuster is a single part (# 11D-F3111-00 ), is it possible you have adjusted it out too far ? Given the vibrations from the 660cc lump under the seat, if there was a problem you would think it would have fallen in already - unless it has ?? or the previous owner was responsible ?? To adjust the pre-load on the Tenere, you should first tighten both adjusters all the way in (maximum pre-load), then adjust out to set the preferable setting to a maximum of 27 complete turns.
__________________
>-------< Never underestimate the power of stupid people in large groups. ![]() ![]() ![]() |
Sponsored Links |
![]() |
Thread Tools | |
Display Modes | |
|
|