.: XT660.com - The #1 XT660 Resource :.

.: XT660.com - The #1 XT660 Resource :. ( https://www.xt660.com/index.php)
-   XT660Z T�n�r� Tech Section ( https://www.xt660.com/forumdisplay.php?f=163)
-   -   Tenere pre-load adjuster problem ( https://www.xt660.com/showthread.php?t=19370)

toshbiker 10-07-12 00:25

?

Gas_Up_Lets_Go 10-07-12 08:37

This is a first, or at least the first time anyone has told of this problem.

The adjuster is a single part (# 11D-F3111-00 ), is it possible you have adjusted it out too far ? Given the vibrations from the 660cc lump under the seat, if there was a problem you would think it would have fallen in already - unless it has ?? or the previous owner was responsible ??

To adjust the pre-load on the Tenere, you should first tighten both adjusters all the way in (maximum pre-load), then adjust out to set the preferable setting to a maximum of 27 complete turns.


All times are GMT +1. The time now is 07:27.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.