Hi,
The engine guard fits straight onto the front mounting points and fits onto the rear mounting points that are a bit further back. Went straight on. It came in Annodised black. Pretty pleased with it though and should hopefully save the water pump too.
I had to tinker a bit with the front fender. I basically took a chance and bought a standard Poliosport YZ Front Fender. I had to leave the tow hook on except i turned it upside down, drilled the holes in the fender a bit so I could move it forward a tad and then finally took the washers off the radiator bolts and replaced with rubber ones to give me another mm or two clearance and that was it. Sounds like a bit of a faff but was not too bad and I can still put it back to normal again! I will post some better picks when I get the chance.
Just need some Knobblies now!
Cheers
Adam
I will post some
Quote:
Originally Posted by
Gas_Up_Lets_Go
What does the new engine guard fix to ?
It looks like it used the same front mounting points as the ABS one ??
And what about the rear ?
Did you paint it, or did it come in black ?
The high mudguard looks good, I think - it's difficult to tell, could we have a picture in the daylight ??
Was it s a straighforward replacement ? any 'adjusting' needed??
Questions questions questions.....
|