Quote:
Originally Posted by
BigB
Fitted a pair of 3" bar raisers
http://www.mandp.co.uk/productinfo.a...-Round-Raisers
fitting was real easy took about 20mins, no clearance problems with cables and wires.
only an inch taller but makes a real difference.
a few tips
undo the nuts on the under side of the yokes before taking the clamps off,
bolts are used insteed of nuts to hold the raisers on, and need to be M10x75.
use lock tight on all bolts.
|
what about the rubber dampermount which is used with standard set up...As this would be redundant is there any extra vibration?
What thread are the M10 75mm bolts as theres some on the fleabay?
Ive just priced a new yam replacement set ( mine are twisted after an off) and they are �79 so this alternative sounds great to me....As I need risers too...