View Single Post
  # 10  
Old 14-05-09, 20:52
Number3 Number3 is offline
SemiPro XT-Moto
 
Join Date: Mar 2008
Location: Stockholm
Posts: 38
Number3 is on a distinguished road
Quote:
Originally Posted by Stewpot666 View Post
Hi

was it easy to fit?

do you have to remove, or change the position of anything?

Stew
Very very easy to fit. It took about 1 hour (inclusing taking the old set off). The only thing you need to move is the rear brake fluid resevoir, but the exhaust system comes with a special braket to move it out the way, so it is no problem at all.

They say that you do not need either to protect any tubes from the heat (as the pipe now runs close to the coolant pipe) but for my own personal peace of mind, I ordered some heat protective tape to go around the coolant pipe. I am sure it would never melt but just in case. The exhaust kits also comes with some heat reflective pad to go under the airbox to prevent that from melting. However the airbox is right about where the pipe goes so I guess this could potentially melt without some sort of heat reflector.

Regards,
Number 3