Quote:
Originally Posted by
frontslide
So in essence bolting the clutch pack up solid with a small gap between the pressure plate and friction plate to allow expansion from the EXP what would this gap need to be as a starting point? this is a good idea.
Also would the EXP be better positioned in the middle of the pack in this scenario?
|
from memory the rekluse unit can exspand 2.5/3mm
i would try 1mm of clearance to see how it goes..
Or so yer can wiggle the plates with yer finger...
be a bit of trial & error to get it right...
yer could also put a couple of belvue washers
on each spacer to give a slight cushion..
belvue washers are cuped spring washer...
quite easy to do as i just lay the bike on it side
& remove the cover.... no draining oil etc...
not sure if putting the unit in the middle would give any
advantage.... but can't hurt to try......
..