|
I thought for �16.00 id try and fit the ebay special. 6 hours later.....
I basically cut the length of it down and then removed the sides with a dremel tool.
The original angle of the number plate bracket was too acute so I scored the back of it and used a heat gun to apply a little heat and bent it to angle I wanted.
I then sandwiched it between the original undergaurd and its mounting points. I then drilled four holes and attached with nuts and bolts.
I was fortunate in that the aftermarket indicators are smaller and they fit perfectly with clearance between the exhaust cans.
A smaller number plate is next BUT Im more than happy with the end result.
�16.00 well spent!!
Last edited by nikroc; 14-10-16 at 17:38.
|