View Single Post
  # 4  
Old 20-02-16, 23:35
bikemad195 bikemad195 is offline
XT-Moto SuperStar
 
Join Date: Nov 2012
Location: hull uk
Posts: 313
bikemad195 is on a distinguished road
Quote:
Originally Posted by konfektyr View Post
Okay, so today while changing my oil I used a torque wrench to tighten the oil filter cover bolts (why the f*ck did I do that??) and stripped the thread that the short one bolts to, not completely though it's still tight enough for me not to be able to screw it off by hand.

Thinking of getting a longer bolt if there are threads that are still intact at the end? Anyone know if this is possible? I will fix this properly at the next oil change. As I understand the bolt is and m6 x 40mm , would a 50mm and a couple of washers and a little blue loctite be fine temporarily, it wouldn't block the oil flow or something like that?

Thanks guys.
i did this with the bottom one of the three be very careful as i tapped mine out to the next size and then pumped it full of wd to wash the swarf back out the hole .... the wd dint fill the hole up instead it pumped all the swarf into the casing and it had to take it off to make sure there was no harmful swarf in my motor i thought it was a blank hole but turns out it wasnt
__________________
Yamaha xt660x 2009 blue/gold mods= iridium plug, stage1+2, removed snorkel, blocked ais, akrapovric pipes, power commander pc3usb (pre made map), adjusted tps, dynojet 02 optimiser 30amp aux relay, smoked puig screen, oxford heated grips and brembo carbon ceramic pads, rfx 30mm bar raisers, puig long adjustable leavers, plus much more and a cheep �30 alarm which stopped it been stolen