If you fancy a bit of a challenge, you can fit a KTM chain guide, detailed by stoicbloke in his post here:
http://www.xt660.com/showthread.php?t=17951
You end up with a great place to site the scottoiler tube.
It just takes a little playing with to get it fitted. I used the existing drain hole in the swingarm, drilled that out and another hole, dropped two bolts through and fitted the chain guide plate to it.
The scottoiler runs through the swingarm and out to this guide.
Took me a couple of hours to get it right, but since then I haven't had to adjust my chain in over 10,000 miles.
Finished product:
Quote:
Originally Posted by
Pleiades
A little tip... Stick a block/wedge of wood under the back wheel before you withdraw the axle; it will stop the wheel dropping and keep the spacers, caliper etc in line and make reinstalling easier.
|
Here's mine. Very important wood
__________________
Bike: 2013 XT660Z, TKC70 tyres
Mods:
Barkbusters, Scottoiler, DIY Tail Mod, DNA Stage 3, Power Commander V & O2 Eliminator, Exan X-Black Stainless exhaust, Tool tube, Ohlins linear front fork springs, Nitron rear shock, JT front and Supersprox rear sprockets, D.I.D. VX 520 chain, Adventure Spec bashplate, DIY USB Outlet, DIY chain guide, Kev's Throttle mod
http://www.facebook.com/onemooseonemotorbike
