Hi guys, due to the crap nature of the coolant reservoir and the fact that its pretty much impossible to actually see the level, i got a bit paranoid and topped up the coolant a little.

Went out on the bike for 20 mins and came back and when i put side stand down and came off, coolant came p***ing out of the bottom, out through the plastic skid plate until it stopped bar a few drips.

Obviously i`ve overfilled it slightly(I can now just see the level bobbing about about 2 cms above max level - and also strangely around the filler cap depending on the angle of the bike, both on the x and y axis).

Is this a cause for concern? Should i try and remove some of the excess coolant from the filler cap? And if so, whats the easiest way?Siphon etc?

Or can I relax and assume that any excess coolant will keep p***ing out the bottom until the max level has been reached? ie nothing is going to go "Boom" if i leave it as is?

Any info will be appreciated.

**Also, whats the best way to clean the parts that are now starting to rust due to bad winter(and being covered and not being used for long periods). Basically the front area of the bike, where the horn and radiator are located, and also the side stand spring etc. Are there any tips to clean this up and maintain it properly?


Ryben