Quote:
Originally Posted by
medo
check the cable connection on the switch attached to side stand ... it could be loose or corroded ... check that the sensor plunger is moving freely ... use some WD-40 on it
check the wiring between ECU and switch connector ... it could be damaged or broken
check that all cable connections to the ECU are attached firmly
you may enter diagnostic mode on your bike display and notice if the code no 20 is changing its value when putting side stand from resting position to drive position ...
|
Ok guys, thanks for the feedback. The bike fired up no probs when I went to have a look last week, but I had a fiddle with the bits as listed above (except for the ECU) & sprayed loads of WD40 on the connectors, which were not corroded. So I went for a ride, after 10 minutes I stopped to get petrol, which is when the predictable happened....she didn't start up
Managed to stop a helpful chap with a van who kindly gave me & the X a lift home.
I was going to check the ECU, but it has some sort of clip holding the cable connector in place. I didn't want to force it off in case I did any further damage. How can I take the clip off to check the ECU connections?
ALso, anyone got any other ideas as to the problem?
Thanks
D