Cheers :-)

I tried this but all i get displayed is the word co,I held down the select and preset buton then switched the ignition on untill the word diag comes on the screen,I then pressed select untill co appears then switch the cut off button to on and start the engin and all that is displayed is the word co.
Am i doing something wrong or is it different on the 07 model.
Thanks,Andy

It`s ok i have sussed how to do it now,My co1 reading is set to 14 and i am getting a little surging at low speed and the bike cuts out now and then,Would it be a good idea to increase this or should i leave alone.
Thanks,Andy

Is it possible to start the engine while in diag mode ?
I tried and didn't succeded.

Going off the top of my head at the moment but do as kev said....

Switch off Engine Run switch, switch OFF Key switch. Press both SELECT & RESET buttons and then switch ON Key switch. Keep SELECT & RESET buttons pressed for at least 8 seconds. Display then changes to "DIAG". Release SELECT & RESET buttons.
Select CO1 mode by pressing the SELECT button.

Then press both the select and reset buttons together until you hear a click.

Then you will see a "0" in the top right of your speedo.

Then start your bike and you can see your rpm.

Hope this is correct as my bike is somewhere else at the moment.

just tried it, works a treat, you guys ROCK

Cheers :headbang:

hey andy, mine was also at 14, i removed the snorkel and put it up to 17 and runs a lot smoother in lower revs now, i would recommend doing it, my bike feels a lot smoother, bring on the $$ for a stage 2 DNA filter i say!!!:deathmetal[1]:

BTW... :lostthread[1]:!!!!!!!!!!!!

[quote=ManicMic;26644]Going off the top of my head at the moment but do as kev said....

Switch off Engine Run switch, switch OFF Key switch. Press both SELECT & RESET buttons and then switch ON Key switch. Keep SELECT & RESET buttons pressed for at least 8 seconds. Display then changes to "DIAG". Release SELECT & RESET buttons.
Select CO1 mode by pressing the SELECT button.

Then press both the select and reset buttons together until you hear a click.

Then you will see a "0" in the top right of your speedo.

Then start your bike and you can see your rpm.


hey, sorry to bother, i done this step by step a couple of times but i see the "0" when i turn the throttle still "0" ???

its an 06

Hi Telesi, I can't think of why the reading would be 0 if you have started the bike, there should be a reading for RPM when you give it a rev... one of the XT guru's should be along soon to help you out, best of luck with it