![]() |
![]() |
![]() |
|
|
XT660Z Mods Share views on all the mods you have done and those you intend to do |
![]() |
|
Thread Tools | Display Modes |
#
1
|
|||
|
|||
High Fender
A mix of mud and stones are somtimes making a lot of noise on the origanal tenere fender.
I was thinking of adding a high fender to my Tenere. I like this one, but in white colour. Its a bit shorter than the usual crossfender. (I dont want to take off :-)) http://www.acerbis.it/moto/index.php...&id=279&cat=18 |
#
2
|
|||
|
|||
I have measured the holes in the bottom yoke of the triple clamp. The hole centres match the same as a WR/YZF moto-x/enduro bike.
So I reckon that a pre-drilled mudguard from the like of UFO or Acerbis will fit. The only short fall will be the back part of the mudguard will be hitting the radiator grill. I think I will cut the read of the mudguard away...... ![]() Timpo. |
#
3
|
|||
|
|||
Ok, here is my high fender try out. Its actualy a Supermotard fender. I just drilled four holes in it.
It takes 10 minutes to switch the fenders. Low fender is better for allday use (riding in rain) I kept the Yamaha towing-ring But maybe it would look better in white? Whats your opinion? |
#
4
|
||||
|
||||
Very *******. (p h a l l i c)
__________________
My Mods | TLC | A good spannering | Kev's brilliant Mods & advice via XTSupporters - Best �10 ever spent. ![]() "Strive to be the person your dog thinks you are" |
#
5
|
|||
|
|||
Looking good, but yes should be white. Have you tested any water crossing and if it splash less up the gap behind the cockpit?
|
#
6
|
|||
|
|||
Actually that doesn't look so bad afterall (although I agree it should be colour matched)... I have a black Pollisport KTM supermoto front mudguard kicking around, I might give that a go...
xxx |
#
7
|
|||
|
|||
Not yet, sunday, I'm going to do a little off-road, looking for water
|
Sponsored Links |
#
8
|
|||
|
|||
Yep, white would be better
|
#
9
|
|||
|
|||
Taste
I also think a high fender looks better.
See my avatar pic. Its a standard fender from UFO. The holes are also standard. I mounted the tow hook upside down at the top of the fender. Don�t miss the fromt breakline holder as you mount the new one! |
#
10
|
|||
|
|||
Looking cool mate!
__________________
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|