Hi all,

You maybe know, I am 10 days old XT600R owner. The first time i tried to see RPM on screen, i did it well. But now no way to see it. Can you please check steps i followed? Where can I be wrong?

1- Engine is off
2- Kill switch is off
3- Press both buttons and don't release
4- Turn key but no release buttons until see DIAG
5- Release buttons
6- Press "select" once to see CO
7- Kill switch is ON
8- Press both buttons to select C1
9- Start the engine

Seems fine, even I am not sure . However, when I had same problem as you, I disconnected the battery for a few minutes. After that it worked as it should.
PS
maybe replacing 7 and 8...

WOW! I remembered!

As I am a newbie, one day i turned the key more then lock position, parking lights went on and my battery got empty. After that day, i couldn't see RPM.

Disconnecting and connecting battery should help me

I will let you results

Reconnetting battery worked well. Thank you!

One more question, when i start cold engine (outdoor temp is 30C) idle speed is 1200-1250 RPM. Thos causes stall if i drive in a minute. If i wait 3 minutes, rpm increases to 1400-1450. Are these values ok?

idle speed is around 1450/1500rpm on an adjusted warm engine.

So it will be better if i increase about 50 rpm. Thus, cold start shows 1300 rpm, in 3 minutes increases to 1500 rpm. Right?

By the way, i am looking to find the thread which shows how to adjust idle speed. Maybe you helpe to see

Spend a little money and join the forum..its a brilliant resource. All you ever need is in here...and you contribute to help the forum help others,just like you.

PS:..two words to help...search ...sticky

Go for a ride 5-10 minutes. Stop and start with the RPM counter. Turn the idle screw (left side, where the acceleration cable goes) until you have 150 for the RPM. That's it, you don't need a thread or a tutorial, it's just a screw you need to turn.