just fitted a MM high 2 into 1 pipe..
MM builds a nice system.. fitted
with out any issues...

so far I have lowered it 50mm
made a set of links with 110mm
hole centres every 10mm in length
drops the bike 25mm 1" ...
turned up 36mm long spring pre load spacers
for the forks to get rid of the sag..

I have a bash plate on order.. B&B Tenere one
should fit or be close enough to make fit now the
pipes are out of the way...
So the next project is a set of bars to protect the
tank wings & rad..not seen a set anywhere I would
spend $ on...
then a rear rack....

Its slowly getting more dirt freindly

Attached Images

	SSA41714.JPG (92.1 KB, 88 views)
	SSA41715.JPG (81.1 KB, 84 views)

Very nice, keep us posted on other mods. I am planning on getting the MM set up soonish.

Why did you not go for the MM sump guard too?


Sent from my iPhone with a smile

The Tenere one has engine bars as well as the guard..

Attached Images

guard-it-cb0023.jpg (45.7 KB, 19 views)

Shipping B&B stuff to the UK is expensive although I did get a couple of B&B luggage plates shipped to one of my wife's friends in Oz just before she visited a few weeks ago. Very good quality they are too.

I will be ordering two of the MM setups just after Christmas and am hoping to get 10% discount too.


Sent from my iPhone with a smile

That one I posted a pic of..Is the same as the B&B one
but is made in the UK...
http://www.adventure-spec.com/defaul...0z-tenere.html