Hi All,

can anybody suggest a good (but cheap) replacement for the standard "bend-easy" bars on a 07 XT660R?

Cheers,

Lance

What are you classing as 'cheap' ?

__________________

Is �30-�50 enough?

Do you want the same size bars?

Renthal 722 �40 will fit, but I think they are slightly lower but wider, apparantly.

It is a bit of a mystery trying to find higher bars on this forum for the R model. Renthal 735 fit apparantly, but I'm not sure if they are that much higher?, but they are wider. Be careful if you are searching the forum, as some people can make comments on threads, but don't have the same model bike.

I am waiting for some Renthal 613 to arrive..should be today....keep an eye on my thread. I think these will be far too wide, so may need the ends trimming, but they are higher. Not sure if they'll fit easily tho' ! Apparantly the clutch cable may be the stumbling block, in not being long enough.

I will have more info for you in the next 24hrs or so......with accurate measurements of the OEM bars, so that you can use that to compare others.

__________________
2008 XTR Mods : DNA Stage 3 Airbox, PC111, Carbon Cans Ovals, Steve Ruth built XTR734cc Big Bore with - High Desert Dyno (HDD)/ Cuervo Racing Gas Flowed / Ported Head fitted with +1mm Valves & uprated Springs, HDD 5050 Camshaft, HDD +3mm Throttle Body, CP 105.5mm 11:1 Piston, Custom Mapping, Piasini ECU, Renthal 613-01, Barkbusters VPS, Pivot Pegz, Touratech Bashplate, Foam Grips, Kev's O2 Sensor Mod, Kev's Extra Coolant Cooler, Wilbers Progressive Fork Springs and Rear Shock

I had a few off last year in the snow and off roading, replaced the standard bars with some spin off Renthal ones but they just werent the best.

Finally got a set of Renthal Street Fighters for about �45, they are a little higher and narrower than the standard ones but i find them better for off roading plus you dont need any new cables

__________________
Plough on

Maxwell - this confuses me, as, according to my B&C Express Renthal Chart, the Streetfighter "789" bar is 755 Width, 100 Height. My OEM is 775 Width, 100 Height minimum (SEE BELOW)..........so your Renthal Streetfighter would be the same height and narrower compared to my OEM handlebars.

I have drawn two conclusions so far, (1)that the OEM handlebars vary, (2) that measuring the OEM handlebar is tricky, and incorrect measurements can be taken when doing comparisons. My measurements of the OEM height varied between 100 and 115.

I spent a while trying to get accurate measurements, but I can honestly say I'm not 100% sure that they are bang -on.

__________________
2008 XTR Mods : DNA Stage 3 Airbox, PC111, Carbon Cans Ovals, Steve Ruth built XTR734cc Big Bore with - High Desert Dyno (HDD)/ Cuervo Racing Gas Flowed / Ported Head fitted with +1mm Valves & uprated Springs, HDD 5050 Camshaft, HDD +3mm Throttle Body, CP 105.5mm 11:1 Piston, Custom Mapping, Piasini ECU, Renthal 613-01, Barkbusters VPS, Pivot Pegz, Touratech Bashplate, Foam Grips, Kev's O2 Sensor Mod, Kev's Extra Coolant Cooler, Wilbers Progressive Fork Springs and Rear Shock