Fitting emulators to forks
 

Any of you guys know the procedure to install racetech emulators to the tenere forks?

post a link to the ones you are looking at...
but if they are the ones I think you are talking about....
Pull the forks apart.... drill the holes in the damping rods bigger so
they no longer work.... reassemble...put the emulators in... you are then transfuring all the rebound & compression damping to the new valves...

PS... DO NOT remove them if you sell the bike unless you replace the damping rods..... As you will be selling a bike in a unsafe state.. totaly no damping in the forks..