throttle body modification!!
 

hello guys! i recently had a small modification to my th. body!i cutted the half of the axle (like kennys mod) and bored with a dremel the entrance and exit but not the middle of the body as i left stock throttle plate!
this days here its raining a lot so i can't go out with my baby!:angry9:
so i decided to mod the throttle body again!i removed the body and the plate !
search my stuff and found an intake from my old car,i removed the throttle plate, its 53mm and the holes for bolds are the same with xt plate!tomorrow i will find a workshop that can bore my body and the plate!ill probably do it 2mm bigger (46mm) as my bike is currently with cans and stage "orestis" airbox :Gangsta2_9BI664:
what is your opinion may i should do it 3mm? more air=more power?im uploading some photos..

http://imageshack.us/a/img820/6816/007uvq.jpg
http://imageshack.us/a/img23/8283/008nce.jpg
http://imageshack.us/a/img825/5991/014tt.jpg
http://imageshack.us/a/img850/5716/011dso.jpg

Nice one we have done +2mm & +3mm throttle bodies over the past few years, do a search on the forum all the Dyno results are there for the bored throttle bodies.

i read them..and saw that from 2mm TB the gain is about 3hp..i hardly believe this (i wish for it)!so what do you suggest Kev +2 or +3?

It all depends on what size valves & Cams you want to run.

well for now i will remain stock!i don't wan't to loose reliability and endurance because i also go for vacations with the bike and km's are a lot for heavy tuned bike!
i made it this morning!:rolltfl:
46mm and a lot thinner plate!i will upload photos later ,i think its badass :box:

Now here are some modded motors with up to 54mm throttle bodies.

http://ledperformanceengines.com/raptor700.htm

http://www.bluetraxx.com/reviews/kds_throttlebody.htm

A +3mm for sale

http://www.ebay.com/itm/Raptor-700-3mm-Bore-Throttle-Body-47mm-TB-w-Injector-/350407548318