![]() |
lower suspension
hi, i would like to drop the suspension on the rear of my ten, what would the lowest i could drop it. i have seen 40mm drop links, can you get lower than that. thanks PAUL.
|
Lowering Links
Have a look here i think they can make you some up aswell .
http://www.projection-components.co....model-88-p.asp
|
I lowered my XTR 50mm...
made a set of links 20mm longer in the hole spaceing.. went from 90mm standard to 110mm Every 10mm longer = 25mm drop.. they are easy to make.. I used 30mm X 6mm stainless flat bar... Drilled 16mm holes @ 110mm spaceing tack weld both links togeather then drill the holes both are the same then.. |
Make sure your side stand is short enough so that you can actually use it after the lowering.
|
All times are GMT +1. The time now is 18:32. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.