.: XT660.com - The #1 XT660 Resource :.

.: XT660.com - The #1 XT660 Resource :. ( https://www.xt660.com/index.php)
-   XT660Z T�n�r� Tech Section ( https://www.xt660.com/forumdisplay.php?f=163)
-   -   What Bars? ( https://www.xt660.com/showthread.php?t=13386)

Peatbog 20-03-10 01:26

Quote:

Originally Posted by Gas_Up_Lets_Go (Post 123902)


i have them on mine, a leftover from my xtr - quality is good, they haven't really tarnished at all.

Gas_Up_Lets_Go 25-03-10 09:36

Quote:

Originally Posted by tripletom (Post 123673)
they are higher than stock.

Quote:

Originally Posted by tripletom (Post 123668)
The 613 enduro high bend are probably about twice is high as stock.

Tom, if you could put a figure on it, what is the hight difference ? Twice as hight is something like another 50mm.... that's quite a rise.

I don't suppose you could stick a ruler next to the bars and give a reading for the distance from the lower (centre of the bar) to the upper (where it levels out) ??? Doesn't need to be acurate, just 'about' will do.


Quote:

Originally Posted by tripletom (Post 123673)
Also, the OE bar end weights will NOT fit.

I don't suppose you can elaborate on this? is it the inside diameter?

uberthumper 25-03-10 12:40

ICBW, but I think Tom's aboard his Ten' somewhere in continental Yurp this week.

Brookydave 02-04-10 21:24

The reason the weights dont fit is two fold:
1. The std bars are internally threaded
2. My Renthal fat bars are very small id compared with the mega heavy std steel bars.

I have fitted Renthal Fat Bars and the converters place them ~25 higher. Very pleased with results. Will take some photos in light tomorrow, or will catch up with you some time - I am 'only' in Lancaster and fancy doing some green lanes.
Cheers
Dave


All times are GMT +1. The time now is 07:45.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.